Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Schematic Reference: Outside Rearview Mirror Schematics | ||||
1 | Did you perform the Power Door Systems Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Does inside mirror change state? | -- | Go to Step 3 | Go to Automatic Day-Night Mirrors Inoperative in Stationary Windows |
3 | While shining a bright light into the sensor on the inside rearview mirror face (facing the rear window), observe the LH outside rearview mirror. Does the LH outside mirror darken? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 4 |
4 |
Is the voltage within the specified range? | 0.75-1.5 V | Go to Step 6 | Go to Step 5 |
5 | Measure the voltage between the signal circuit of the LH outside mirror element to a good ground. Is the voltage within the specified range? | 0.75-1.5 V | Go to Step 8 | Go to Step 7 |
6 |
Is the voltage within the specified range? | 0.75-1.5 V | Go to Step 9 | Go to Step 10 |
7 | Test the signal circuit of the LH outside rearview mirror element for an open or short to battery positive voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find or correct the condition? | -- | Go to Step 15 | Go to Step 11 |
8 | Test the ground circuit of the LH outside rearview mirror element for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find or correct the condition? | -- | Go to Step 15 | Go to Step 11 |
9 | Inspect for poor connections at the harness connector of the LH outside rearview mirror face. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find or correct the condition? | -- | Go to Step 15 | Go to Step 12 |
10 | Inspect for poor connections at the harness connector of the LH outside rearview mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find or correct the condition? | -- | Go to Step 15 | Go to Step 13 |
11 | Inspect for poor connections at the harness connector of the inside rearview mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find or correct the condition? | -- | Go to Step 15 | Go to Step 14 |
12 | Replace the LH outside rearview mirror face. Refer to Outside Rearview Mirror Glass Replacement . Did you complete the replacement? | -- | Go to Step 15 | -- |
13 | Replace the LH outside rearview mirror. Refer to Outside Rearview Mirror Replacement . Did you complete the replacement? | -- | Go to Step 15 | -- |
14 | Replace the inside rearview mirror. Refer to Inside Rearview Mirror Replacement in Stationary Windows. Did you complete the replacement? | -- | Go to Step 15 | -- |
15 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
