GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Chevy C Silverado - 2WD 🢒 Body and Accessories 🢒 Interior Trim 🢒 Shift Lever Replacement

Removal Procedure

    Object Number: 394463 Size: SH
  1. Remove four plastic retainer plugs securing the shift boot retainer to the shift boot.
  2. Remove eight screws securing the shift boot and insulator to the floor panel.
  3. Remove the retainer and shift boot from the shift lever.

    4. Object Number: 394462 Size: SH
  4. Remove the shift lever from the shift tower.

    5. Do not remove the shift lever adjusting nut.

Installation Procedure

    Object Number: 394462 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the shift lever to the shift tower.

    2. If required, use the shift lever adjusting nut to center the shift lever.

    Tighten
    Tighten the shift lever nut to 47 N·m (35 lb ft).


    Object Number: 394463 Size: SH
  2. Position the retainer and shift boot onto the shift lever.
  3. Install eight screws securing the shift boot and insulator to the floor panel.

    4. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  4. Install four plastic retainer plugs securing the shift boot retainer to the shift boot.