Auxiliary Generator Replacement 6.6 L Engine

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the drive belt. Refer to Drive Belt Replacement in Engine Mechanical - 6.6 L.
3. Disconnect the auxiliary generator electrical connector (4).



4. Remove the auxiliary generator bolts.
5. Remove the auxiliary generator.



6. Remove the generator cable from the auxiliary generator, perform the following:

6.1.	Slide the boot down revealing the terminal stud.

6.2.	Remove the generator cable nut from the terminal stud.

6.3.	Remove the generator cable.




7. If required, remove the auxiliary generator bracket bolt.
8. Remove the auxiliary generator bracket.

1. If removed, install the auxiliary generator bracket.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the auxiliary generator bracket bolt.

Tighten
Tighten the auxiliary generator bracket bolt to 50 N·m (37 lb ft).




3. Install the generator cable to the auxiliary generator, perform the following:

3.1.	Install the generator cable.

3.2.	Install the generator cable nut to the terminal stud.

Tighten
Tighten the generator cable nut to 9 N·m (80 lb in).

3.3.	Slide the boot over the terminal stud.




4. Install the auxiliary generator.
5. Install the auxiliary generator bolts.

Tighten
Tighten the auxiliary generator bolts to 50 N·m (37 lb ft).




6. Connect the auxiliary generator electrical connector (4).
7. Install the drive belt. Refer to Drive Belt Replacement in Engine Mechanical - 6.6 L.
8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .