Some 1983 - 1991 G1, G2, and G3 vehicles with 6.2L diesel engines may experience increased splashing of rain water into the engine compartment in the vicinity of the alternator. In an effort to improve this condition and prevent the contamination of underhood components a revised right wheel well splash shield has been released for vehicles equipped with the 6.2L diesel engine.
This new splash shield (P/N 15685862) is installed in the front of the right wheel well opening with four plastic rivets (P/N 14063981).
1. Raise the front end of the vehicle with a floor jack to obtain sufficient clearance from the tire. It is not necessary to remove the tire.
2. Position the splash shield (P/N 15685862) in the wheel well opening as shown in Figure 1. Using the splash shield as a template, mark the position of the four attaching holes.
3. Using a 1/4 inch drill bit, drill the four attaching holes in the fender well.
4. Install the splash shield with the four retaining rivets (P/N 14063981) or equivalent.
Part Quantity Description Number Required ------------- -------- --------- Splash Shield 15685862 1 Rivet 14063981 4
Parts are currently available from GMSPO.
For vehicles repaired under warranty use:
Labor Operation: T7341 Labor Time: 0.3 hrs.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.