For 1990-2009 cars only
Accelerator Controls Accelerator Control Cable
Removal Procedure
- Remove the throttle cable from the throttle lever.
- Remove the accelerator cable from the engine cable bracket.
- Remove the accelerator cable from the cable routing bracket.
- Remove the accelerator cable from the accelerator pedal (2).
- Remove the accelerator cable from the dash panel (1).
Installation Procedure
- Install the accelerator cable to the dash panel (1).
- Install the accelerator cable to the accelerator pedal (2).
- Install the accelerator cable to the cable routing bracket.
- Install the accelerator cable to the engine cable bracket.
- Install the throttle cable to the throttle lever.
Accelerator Controls Accelerator Pedal Replacement
The accelerator pedal (3) through a cable (2) controls the throttle. There are no linkage adjustments. Replace the accelerator control cable with an identical replacement part.
Check all linkages and cables in order to assure free movement with no rubbing, chafing, or binding. The accelerator pedal must operate freely, without binding, between the full closed and the wide open throttle (WOT).
Observe the following when performing service on the accelerator pedal:
| • | The mounting surface between the support and the dash panel must be free of insulation. The carpet and padding in the pedal and tunnel area must be positioned to lay flat and be free of wrinkles and bunches. |
| • | Slip the accelerator control cable through the slot in the rod (4) before installing the retainer (1) in the rod. Make sure it is seated properly. Use care in pressing the retainer into the hole, so the cable is not kinked or damaged. |
| • | The linkage must operate freely without binding between the closed throttle and the full throttle position. |
| • | Do not place the wire, hoses, cable, and other flexible components within 13 mm (0.52 in.) of the cable or rod, at any point in their travel. |
