Refer to
Power, Ground, MIL, and DLC
.
Circuit Description
A dash light is illuminated by the PCM if the diagnostics have detected certain errors related to the engine performance or the engine sensor status. When the PCM is commanding the MIL ON, the voltage potential of the circuit will be low (near 0 volts). When the PCM is commanding the MIL OFF, the voltage potential of the circuit will be high (near the battery volts). The primary function of the PCM is to supply the ground for the MIL circuit. This is a type D DTC
Conditions for Setting the DTC
| • | The MIL is requested ON. |
| • | The voltage on the MIL control circuit is high (near the battery volts). |
or
| • | The MIL is requested OFF. |
| • | The voltage on the MIL control circuit is low (near 0 volts). |
Action Taken When the DTC Sets
The MIL will not turn ON.
Conditions for Clearing the MIL/DTC
| • | A History DTC will clear after forty consecutive warm-up cycles during which the diagnostic does not fail (the coolant temperature has risen 5°C (40°F) from the start up coolant temperature and the engine coolant temperature exceeds 71°C (160°F) during that same ignition cycle). |
| • | Use of a Scan tool will clear the DTC codes. |
Diagnostic Aids
A malfunctioning bulb, the control circuit shorted to ground or battery voltage, will cause a P1641 to set.
An intermittent may be caused by the following:
| • | Poor connections |
| • | Rubbed through wire insulation |
| • | Broken wire inside the insulation |
Test Description
The number(s) below refer to the Step number(s) on the Diagnostic Table.
-
Be sure that both the ON and the OFF states are commanded. Repeat the commands as many times as necessary.
-
If no trouble is found in the control circuit or in the connection at the PCM, this could be an indication that the PCM is malfunctioning; however, this is an extremely unlikely failure.
Step | Action | Value(s) | Yes | No | ||||||
|---|---|---|---|---|---|---|---|---|---|---|
1 |
Important: Before clearing the DTCs, use the scan tool in order to record the Freeze Frame and the failure records for reference, as the data will be lost when the Clear Info function is used. Was the Powertrain On-Board Diagnostic (OBD) System Check performed? | -- | ||||||||
Does the lamp turn ON and OFF with each command? | -- | |||||||||
3 | The DTC is intermittent. If no additional DTCs are stored, refer to Diagnostic Aids. If any additional DTCs were stored, refer to those table(s). Are there any additional DTCs stored? | -- | Go to the applicable DTC table | Go to Diagnostic Aids | ||||||
4 |
Is the lamp OFF? | -- | ||||||||
5 |
Is the lamp ON? | -- | ||||||||
6 |
Was a repair performed? | -- | ||||||||
7 | The MIL control circuit is shorted to ground. Repair as necessary. Is the action complete? | -- | -- | |||||||
8 | Check the MIL circuit for the following:
Is the repair complete? | -- | -- | |||||||
Replace the PCM. Important: The new PCM must be programmed. Refer to Powertrain Control Module Replacement/Programming .Is the action complete? | -- | -- | ||||||||
10 |
Does the Scan Tool indicate that this diagnostic Passed? | -- | ||||||||
11 | Use the Scan Tool in order to select Capture Info, Review Info. Are there any DTCs displayed that have not been diagnosed? | -- | Go the Applicable DTC Table | System OK |
