1. Grasp both sides of the quick-connect fitting. Twist the female connector 1/4 turn in each direction in order to loosen any dirt within the quick-connect fitting.

Caution: Wear safety glasses when using compressed air in order to prevent eye injury.




2. Use compressed air in order to blow any dirt out of the quick-connect fitting.



3. Choose the correct tool from the J 37088-A tool set for the correct size of the fitting.
4. Insert the tool into the female connector, then push inward to release the locking tabs.



5. Pull the connection apart.

Notice: Use an emery cloth in order to remove rust or burrs from the fuel pipe. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface.

6. Use a clean shop towel in order to wipe off the male fuel pipe end.
7. Inspect both ends of the quick-connect fitting for dirt and burrs.
8. Clean or replace the components/assemblies as required.

Caution: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.

1. Apply a few drops of clean engine oil to the male fuel pipe end.



2. Push both sides of the quick-connect fitting together in order to cause the retaining tabs/fingers to snap into place.



3. Once installed, pull on both sides of the quick-connect fitting in order ensure that the connection is secure.