Turbine Shaft Assemble. Chevrolet Chevy G Van 1996

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 1996 🢒 Chevy G Van 🢒 Transmission/Transaxle 🢒 Automatic Transmission - 4L80-E 🢒 Turbine Shaft Assemble

Tools Required

•	J 38736-1 Turbine Shaft Seal Installer

•	J 38736-2 Turbine Shaft Seal Installer

•	J 38736-3 Turbine Shaft Seal Sizer

•	J 38736-4 Turbine Shaft Seal Sizer

•	J 38736-5 Turbine Shaft Seal Pusher

•	J 38736-6 Turbine Shaft Seal Pusher

Place the J 38736-1 onto the turbine shaft (502).
Set the J 38736-1 to position #1.
Install the turbine shaft front oil seal (501) using the J 38736-5 .
Remove the tools.

Important: Be sure to use the small chamfered end of the J 38736-3 in order to size the lower turbine shaft front oil seal. Then use the larger chamfered end of the J 38736-3 in order to size the upper turbine shaft front oil seal.

Place the J 38736-3 over the turbine shaft front oil seal with the small chamfer down.
Leave the J 38736-3 on the turbine shaft front oil seal for at least one minute in order to allow the turbine shaft front oil seal to become the proper size.

Place the J 38736-1 onto the turbine shaft (502).
Set the J 38736-1 to position #2.
Install the turbine shaft front oil seal (501) using the J 38736-5 .
Remove the tools.

Place the J 38736-3 over the turbine shaft front oil seal with the large chamfer down.
Leave the J 38736-3 on the turbine shaft front oil seal for at least one minute to allow the turbine shaft front oil seal to become the proper size.

Turn the turbine shaft (502) over.
Place the J 38736-2 onto the turbine shaft.
Set the J 38736-2 to position #1.
Install the turbine shaft rear oil seal (503) using the J 38736-6 .
Remove the tools.

Important: Be sure to use the small chamfered end of the J 38736-4 in order to size the lower turbine shaft rear oil seal. Then use the larger chamfered end of the J 38736-4 in order to size the upper turbine shaft rear oil seal.

Place the J 38736-4 over the turbine shaft rear oil seal with the small chamfer down.
Leave the J 38736-4 on the turbine shaft rear oil seal for at least one minute in order to allow the turbine shaft rear oil seal to become the proper size.

Place the J 38736-2 onto the turbine shaft (502).
Set the J 38736-2 to position #2.
Install the turbine shaft rear oil seal (503) using the J 38736-6 .
Remove the tools.

Place the J 38736-4 over the turbine shaft rear oil seal with the large chamfer down.
Leave the J 38736-4 on the turbine shaft rear oil seal for at least one minute in order to allow the turbine shaft rear oil seal to become the proper size.