Tools Required

J 25025 -5 Guide Pin

1. Install the J 25025 -5 into the control valve body bolt hole where the manual shaft detent roller and spring assembly is mounted.
2. Install the control valve body gasket (45).
3. Install the control valve body spacer plate (46).



4. Install the third and fourth clutch accumulator housing gasket (47).
5. Install the third clutch accumulator piston spring (50). This spring is the longer of the two springs.
6. Install the fourth clutch accumulator piston spring (49).
7. Install the third and fourth clutch accumulator housing assembly (51) onto the control valve body assembly (44).
8. Install the six accumulator housing bolts (53). Start the bolts finger tight and work towards the opposite end.



9. Tighten the accumulator housing bolts (53) sequentially.

Tighten
Tighten the bolts to 11 N·m (97 lb in).

10. Remove the J 25025 -5.