Installation Procedure
Tools Required
J 34730-1A Fuel Pressure Gage
Caution: Gasoline or gasoline vapors are highly flammable. A fire could occur
if an ignition source is present. Never drain or store gasoline or diesel
fuel in an open container, due to the possibility of fire or explosion. Have
a dry chemical (Class B) fire extinguisher nearby.
Caution: Wrap a shop towel around the fuel pressure connection in order to reduce
the risk of fire and personal injury. The towel will absorb any fuel leakage
that occurs during the connection of the fuel pressure gage. Place the towel
in an approved container when the connection of the fuel pressure gage
is complete.
- Remove the engine sight shield. Refer to
Upper Intake Manifold Sight Shield Replacement
in Engine Mechanical-4.8L,
5.3L, and 6.0L.
- Remove the fuel rail pressure fitting cap.
- Connect the J 34730-1A
to the fuel pressure valve. Wrap a shop towel around the fitting while connecting
the gage in order to avoid spillage.
- Install the bleed hose on J 34730-1A
into an approved container.
Removal Procedure
- Remove the bleed hose on the J 34730-1A
from the approved container.
- Remove the shop towel from around the fitting and discard into an approved
container.
- Disconnect the J 34730-1A
from the fuel pressure valve.
- Install the fuel rail pressure fitting cap.
- Install the engine sight shield. Refer to
Upper Intake Manifold Sight Shield Replacement
in Engine Mechanical-4.8L, 5.3L, and
6.0L.