GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Chevy K Silverado - 4WD 🢒 Engine 🢒 Engine Electrical 🢒 Hood Link Replacement

Removal Procedure

    Object Number: 385497 Size: SH

    Caution:  When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

  1. Raise and support the front of the hood (1).
  2. Remove the bolts (7) holding the hood link assembly to the hood hinge.
  3. Remove the bolts (5) holding the hood link assembly to the fender.
  4. Remove the hood link assembly from the vehicle.

Installation Procedure

    Object Number: 385497 Size: SH
  1. Position the hood link assembly (6) to the vehicle.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolt (5) holding the hood link assembly to the fender.

    3. Tighten
    Tighten the link assembly to the fender bolt to 25 N·m (18 lb ft).

  3. Install the fender bolt (7) holding the hood link assembly to the hood hinge.

    4. Tighten
    Tighten the hinge bolts to 25 N·m (18 lb ft).