These diagnostic procedures help you find and repair automatic transfer case (ATC) system malfunctions. This service category also contains information for repairing ATC system malfunctions. For best results, use the diagnostic tables and follow the sequence listed below:
- Perform the Transfer Case Diagnostic System Check. All ATC diagnostics must begin with the Transfer Case Diagnostic System Check. The Transfer Case Diagnostic System Check determines the following:
- Refer to the diagnostic table as directed by the Transfer Case Diagnostic System Check. The diagnostic tables help enable you to diagnose any ATC system malfunction. Bypassing these procedures may result in the following:
- Repeat the Transfer Case Diagnostic System Check after you perform any repair or diagnostic procedure. This verifies that you correctly performed the repair. This also ensures that other malfunctions do not exist.
| • | Proper SERVICE 4WD indicator operation. |
| • | Ability of the transfer case shift control module to communicate through the Data Link Connector (DLC) |
| • | Existence of ATC DTCs |
| • | Extended diagnostic time |
| • | Incorrect diagnosis |
| • | Incorrect parts replacement |
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
This step inspects for lack of communication that may be due to a partial malfunction of the Class 2 serial data circuit or due to a total malfunction of the Class 2 serial data circuit. The specified procedure determines the particular condition.
-
The presence of DTCs indicates that the transfer case shift control module has detected a fault. Go to symptoms for other concerns.
-
The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure compiles all the available information before tests are performed.
-
Vehicle speed is provided to the transfer case shift control module via Class 2 and can effect the setting of DTC C0300. Perform the diagnostics for powertrain DTC P0502 and DTC P0503 first.
-
Perform diagnostics for DTC C0300 and DTC C0305 first before addressing other DTCs. DTC C0300 and DTC C0305 can be responsible for setting other DTCs.
Step | Action | Yes | No |
|---|---|---|---|
1 | Install a scan tool. Does the scan tool power up? | Go to Step 2 | Go to Scan Tool Does Not Power Up in Data Link Communications |
Important: The ATC module does not come from the manufacturer already programmed. Use the scan tool to program the module with the latest calibrations, failure to do so causes no communications with the ATC module. Does the scan tool communicate with the transfer case shift control module? | Go to Step 3 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | |
Select the Transfer Case Shift Control Module display DTCs function on the scan tool. Does the scan tool display any DTCs? | Go to Step 4 | Go to Symptoms - Transfer Case | |
Does the scan tool display any DTCs which begin with a "U"? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | Go to Step 5 | |
Does the scan tool display DTC P0502 or P0503? | Go to Applicable Powertrain OBD Diagnostic System Check | Go to Step 6 | |
Does the scan tool display DTC C0300 or C0305? |
