Important: Before beginning the following service procedure, place a automatic transmission equipped vehicle into the PARK position, place a manual transmission equipped vehicle into FIRST GEAR. Then place the transfer case in the 2 HI position.

1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
2. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .

Important: When performing this service procedure, use a small pocket screwdriver in order to release the retaining clip on the ends of the control rod.

3. Remove the control rod from the control lever.



4. Remove the control rod from the shift lever.
5. Remove the control rod.

Important: 

1. Install the control rod onto the control lever first.



2. Slide the control rod forward.
3. Install the control rod onto the shift control lever.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Tighten the control rod adjusting bolt.

Tighten
Tighten the bolt to 15 N·m (11 lb ft).

5. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement .
6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .