Important: The following service procedure must be performed with the assistance from another technician.
22.1. | Slide the transfer case straight back toward the rear of the vehicle. |
22.2. | Rotate the transfer case so that the front output shaft is above the torsion bar bracket. |
22.3. | Rotate the transfer case (with the input shaft slightly lowered) so that the transfer case is parallel to the torsion bar bracket. |
22.4. | Lower the transfer case. |
Important: The following installation procedure must be performed with the assistance of another technician.
1.1. | Raise the transfer case into position (the transfer case should be parallel to the torsion bar bracket). |
1.2. | Rotate the transfer case so that it is in line with the adapter. |
Notice: Refer to Fastener Notice in the Preface section.
1.3. | Install the transfer case to the adapter. |
Tighten
Tighten the nuts to 50 N·m (37 lb ft).
Tighten
Tighten the bolts to 47 N·m (35 lb ft).
Tighten
Tighten the bolts to 70 N·m (52 lb ft).
Tighten
Tighten the nuts to 40 N·m (30 lb ft).