Notice: Broken or deteriorated mounts can cause misalignment and destruction of certain drive train components. When a single mount breaks, the remaining mounts are subjected to abnormally high stresses.

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the transmission mount to crossmember nuts.
3. Remove the transmission mount bolts to the transmission.
4. Raise the transmission using a suitable transmission jack, just enough in order to permit the removal of the mount.
5. Remove the transmission mount.

1. Install the rear transmission mount.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the transmission mount bolts.

Tighten
Tighten the transmission mount bolts to 50 N·m (37 lb ft).

3. Lower the transmission.
4. Install the transmission mount to crossmember nuts.

Tighten
Tighten the transmission mount to crossmember nuts to 54 N·m (40 lb ft).

5. Lower the vehicle.