Circuit Description
Vehicles currently using the 8.1L gas engine use a 3 wire system to communicate engine torque data/requests between the powertrain control module (PCM) and the transmission control module (TCM).
DTC P1779 is a type B DTC.
Conditions for Running the DTC
| • | Components are powered and ignition voltage is greater than 9.0 volts and less than 18 volts. |
| • | Engine speed is greater than 200 RPM and less than 7,500 RPM for 5 seconds. |
| • | Pulse width modulation (PWM) driver demand torque option is selected in transmission calibration. |
Conditions for Setting the DTC
DTC P1779 sets if managed engine torque, net, signal is less than 1.5 percent, or greater than 98.5 percent for greater than 2 seconds.
Action Taken When the DTC Sets
| • | The TCM illuminates the malfunction indicator lamp (MIL) during the second consecutive trip in which the Conditions for Setting the DTC are met. |
| • | DTC 1779 is stored in TCM history. |
| • | The TCM defaults to a calculated managed torque, net, input value using throttle and engine speed. |
| • | The TCM defaults to a calculated unmanaged torque, gross, input value using throttle and engine speed. |
| • | The TCM inhibits torque converter clutch (TCC) engagement. |
Conditions for Clearing the DTC
A scan tool can clear the code from TCM history. The TCM automatically clears the DTC from TCM history if the vehicle completes 40 warm-up cycles without failure.
Diagnostic Aids
| • | Inspect the wiring for poor electrical connections at the TCM. Inspect for the following conditions: |
| - | A bent terminal |
| - | A backed-out terminal |
| - | A damaged terminal |
| - | Poor terminal tension |
| - | A chafed wire |
| - | A broken wire inside the insulation |
| • | When diagnosing for an intermittent short or open, massage the wiring harness while watching the test equipment for a change. |
| • | You may have to drive the vehicle in order to experience a condition. |
Test Description
The numbers below refer to the step numbers on the diagnostic table.
Step | Action | Value | Yes | No | ||||||
|---|---|---|---|---|---|---|---|---|---|---|
Schematic Reference: Automatic Transmission Controls Schematics | ||||||||||
1 | Did you perform the Diagnostic System Check - Automatic Transmission? | -- | Go to Step 2 | |||||||
Important: Before clearing the DTC, use the scan tool in order to record the Freeze Frame and Failure Records for reference. The Clear Info function will erase the data. Did you find and correct a condition? | -- | Go to Step 8 | Go to Step 3 | |||||||
3 |
Did you find and correct a condition? | -- | Go to Step 8 | Go to Step 4 | ||||||
4 |
Did you find and correct a condition? | -- | Go to Step 8 | Go to Step 5 | ||||||
5 | Verify that the PCM has the proper model year software and calibration. This wiring option is only used with the 8.1L gas engine. Was the software and calibration current and proper for the engine? | -- | Go to Step 7 | Go to Step 6 | ||||||
6 | Install the correct PCM calibration. Refer to Powertrain Control Module (PCM) Programming. Is the calibration complete? | -- | Go to Step 8 | -- | ||||||
7 | Replace the PCM. Refer to Powertrain Control Module Replacement in Engine Controls - 8.1 L. Did you complete the replacement? | -- | Go to Step 8 | -- | ||||||
8 | Perform the following procedure in order to verify the repair:
Has the test run and passed? | -- | System OK | Go to Step 1 | ||||||
