Rear Winch Harness and Connector Replacement LSSV

Caution: Refer to Battery Disconnect Caution in the Preface section.




1. Disconnect the battery cables. Refer to Battery Cable Disconnect and Connection in Engine Electrical.
2. Remove the negative cable (3) from the junction block.
3. Remove the positive cable (1) from the junction block (2).



4. Remove the wiring harness straps securing the cable.
5. Remove the clamp bolt and clamp from cable.
6. Remove the bolt (1) securing cable connector to the bracket.
7. Remove the cable (2) from the vehicle.

Note cable routing for installation.

1. Install the cable (2) onto the vehicle in the same location as removed.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the connector onto the bracket and secure with bolt (1).

Tighten
Tighten the connector bolt to 10-15 N·m (7-11 lb ft).

3. Install the clamp and secure with bolt.
4. Working from the rear to the front of the vehicle install the wiring harness straps.



5. Install the positive cable (1) to the junction block (2).
6. Install the negative cable (3) to the junction block (2).

Tighten
Tighten the junction block nuts to 34 N·m (25 lb ft).

7. Connect the battery cables. Refer to Battery Cable Disconnect and Connection .

Rear Winch Harness and Connector Replacement Maintenance Body

Caution: Refer to Battery Disconnect Caution in the Preface section.




1. Disconnect the battery cables. Refer to Battery Cable Disconnect and Connection in Engine Electrical.
2. Remove the negative cable from the engine block.
3. Remove the positive cable (1) from the junction block (2).



4. Remove the wiring harness straps securing the cable.
5. Remove the bolt (2) securing cable connector to the bracket.
6. Remove the cable (3) from the vehicle.

Note cable routing for installation.

1. Install the cable (3) onto the vehicle in the same location as removed.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the connector onto the bracket and secure with bolt (2).

Tighten
Tighten the connector bolt to 10-15 N·m (7-11 lb ft).

3. Working from the rear to the front of the vehicle install the wiring harness straps.



4. Install the positive cable (1) to the junction block (2).

Tighten
Tighten the junction block nut to 9 N·m (80 lb in).

5. Install the negative cable to the engine block.

Tighten
Tighten the negative cable bolt to 34 N·m (25 lb ft).

6. Connect the battery cables. Refer to Battery Cable Disconnect and Connection .