GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1334847  Size: SH
  1. Remove the oil level indicator.
  2. Remove the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side in Engine Exhaust.
  3. Remove the starter motor. Refer to Starter Motor Replacement in Engine Electrical.
  4. Remove the oil level indicator tube bolt at the fuel injection control module bracket.
  5. Remove the oil level indicator tube and O-ring seals.
  6. Remove and discard the O-ring seals.

Installation Procedure


    Object Number: 1334847  Size: SH
  1. Install NEW O-ring seals onto the oil level indicator tube.
  2. Lightly lubricate the O-ring seals with engine oil.
  3. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the oil level indicator tube.
  5. Install the oil level indicator tube bolt at the fuel injection control module bracket.
  6. Tighten
    Tighten the bolt to 21 N·m (15 lb ft).

  7. Install the starter motor. Refer to Starter Motor Replacement in Engine Electrical.
  8. Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side in Engine Exhaust.
  9. Install the oil level indicator.