For 1990-2009 cars only
Removal Procedure
- Remove the right side end panel.
- Push in the tabs in order to remove the fuse block.
- Pull out the fuse block out of the instrument panel (I/P) in order to remove the retaining bolt.
- Loosen the bolt.
- Insert a screw driver between the wire harness block and fuse block in order to separate.
- Separate the fuse block from the I/P harness block.
- Remove the I/P wiring harness block from the vehicle.
Installation Procedure
- Install the fuse block to the I/P wire harness block.
- Install the retaining bolt.
- Install the fuse block to the I/P until it clicks in place.
- Connect the wiring connectors to the fuse block.
- Install the right side end panel.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolt to 6 N·m (53 lb in).
Refer to Electrical Center Identification Views to ensure the right connections are made.
