Tools Required
• | J 43770 Main, Lube,
Converter Relief Valve Spring Compressor |
- Install J 24459-5
(1)
onto J 43770
(2).
- Position the oil pump cover assembly (1) on the work table so that the
rear of the oil pump cover assembly is facing down.
- Align J 43770
(5)
and J 24459-5
(4) with
the oil pump cover so that:
• | The threaded rod of J 43770
is facing down. |
• | Two bolt holes of J 43770
align with the bolt holes of the oil pump cover. |
- Install J 43770
(5)
onto the oil pump cover assembly.
- Install 2 oil pump cover retaining bolts (2).
- Align the slot of J 24459-5
(4) with the retainer pin (3).
- Using J 24459-5
(4)
and J 43770
(5), compress
the pressure regulator valve spring until the retainer pin (3) is loose.
- Turn the oil pump cover so that the pin (3) is accessible.
- Using a pick, push the pin through the oil pump cover (1).
- Relieve the pressure regulator valve spring tension.
- Remove tools J 43770
andJ 24459-5
.
- Remove the stop (3), the spring (2),
and the pressure regulator valve (1).
- Using J 43770
(2),
compress the 1-2-3-4 clutch backfill valve spring until the retaining
clip (1) is loose.
- Remove the clip.
- Remove the spring (2) and the 1-2-3-4 clutch backfill
valve (1).
- Align the slot of J 24459-5
(2) with the retainer pin (1).
- Using J 24459-5
(2),
compress the oil pump lube regulator valve spring until the retainer pin (1)
is loose.
- Remove the pin.
- Remove the stop (4), the spring (2)
and the oil pump lube regulator valve (1).
- For some models, remove the O-ring (3) from the stop (4).
- Using J 43770
(2), compress the torque converter clutch (TCC) relief valve
spring until the retaining clip (1) is loose.
- Remove the clip.
- Remove the spring (2) and the TCC
relief valve (1).
- Install J 24459-5
(1)
onto J 43770
(2).
- Align J 43770
(5)
and J 24459-5
(4) with
the oil pump cover so that the following conditions are met:
• | The threaded rod of J 43770
is facing down. |
• | Two J 43770
bolt
holes align with 2 bolt holes in the oil pump cover. |
- Install J 43770
(5)
onto the oil pump cover assembly (1).
- Install 2 oil pump cover retaining bolts (2).
- Align the slot in J 24459-5
(4) with the retainer pin (3).
- Using J 24459-5
(4)
and J 43770
(5), compress
the TCC valve spring until the retainer pin (3) is loose.
- Using a pick, push the pin through the oil pump cover (1).
- Turn the oil pump cover so that the retaining pin is accessible.
- Relieve the TCC valve spring tension.
- Remove tools J 43770
(5)
and J 24459-5
(4) .
- Remove the stop (4), the spring (3),
and the TCC valve (2).