Tools Required
J 43780 Transmission Case
Locating Pin Installer
Transmission Case Fill Plug Disassemble
- Remove the fill tube plug (1).
- Remove the fill tube seal (2).
- Install the fill tube seal (2) into the transmission case.
- Align the tab on the fill plug (1) with the tang on the transmission
case.
Important: The fill plug retaining tab snaps into place
over a tang on the transmission case.
- Install the fill plug (1) into the fill tube seal (2).
- Press the fill plug down until the retaining tab locks into place.
Transmission Case Vent Disassemble
- Pry the vent cap (1) away from the transmission case.
- If the vent tube (2) remains, gently pry the vent tube from the
transmission case.
- Gently tap a new vent assembly into the transmission case until the vent
is seated.
Transmission Case Locating Pin Disassemble
Notice: DO NOT mar the transmission case surface when removing
the locating pin. An unmarred surface is required to maintain the seal between the
low and reverse clutch housing assembly and the transmission case.
Important: Do not replace the transmission case locating
pin unless the locating pin is damaged.
- Remove the locating pin (1) from the rear surface of the transmission
case.
- Install a new locating pin (1) into J 43780
(2).
- Using J 43780
(2),
drive the locating pin until seated.
Locating Pin Installed Height
Make sure the locating pin
is installed to a height of 20.80-21.20 mm (0.819-0.835 in)
above the transmission case rear surface.