Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

Important: Prior to camshaft sensor removal, align the timing mark on the front engine cover and the crankshaft balancer to 0 degrees before top dead center (BTD). Be sure the bank 1 cylinder 1 is on the compression stroke, or that the intake and exhaust valves are closed.

Important: Remove the camshaft sensors top cover. Install the camshaft sensor with the flat side of the cap toward the front of the engine.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten
Tighten the bolt to 33 N·m (24 lb ft).