Name | Location | Locator View | Connector End View |
|---|---|---|---|
Battery | On the outboard side of the right frame rail to the rear of the engine | -- | |
Engine Wiring Harness Junction Block (Underhood Fuse Relay Center) | At the lower LH corner of the cowl | Power and Grounding Component Views in Wiring Systems | Power and Grounding Connector End Views in Wiring Systems |
Fuse Block | Body builder installed | Electrical Center Identification Views in Wiring Systems | Power and Grounding Connector End Views in Wiring Systems |
Generator | On the upper right side of the engine | ||
Ignition Switch | On the right side of the steering column | Power and Grounding Component Views in Wiring Systems | Power and Grounding Connector End Views in Wiring Systems |
Park/Neutral Switch | In the left side of the transmission housing, toward the bell housing | Engine Controls Component Views in Engine Controls | Engine Controls Connector End Views in Engine Controls |
Powertrain Control Module (PCM) | Above the radiator, to the right of the driver island | Engine Controls Component Views in Engine Controls | Powertrain Control Module Connector End Views in Engine Controls |
Starter Motor | On the lower right side of the engine | -- | |
Starter Relay | In the engine wiring harness junction block (underhood fuse relay center), outside row, at the bottom | Power and Grounding Component Views in Wiring Systems | Power and Grounding Connector End Views in Wiring Systems |
Starter Solenoid | On the lower right side of the engine, part of the starter motor assembly | -- | |
C100 | At the lower left corner of the bulkhead; the IP harness end is attached to the bulkhead | Harness Routing Views in Wiring Systems | Inline Harness Connector End Views in Wiring Systems |
C101 | Engine side of the bulkhead near C100 | Harness Routing Views in Wiring Systems | Inline Harness Connector End Views in Wiring Systems |
C202 | On top of the steering column | Harness Routing Views in Wiring Systems | Inline Harness Connector End Views in Wiring Systems |
G102 | On the front center of the engine, at the thermostat housing | Power and Grounding Component Views in Wiring Systems | -- |
G104 | Rear of the RH cylinder bank | Power and Grounding Component Views in Wiring Systems | -- |
G109 | Battery negative terminal ground, at the rear of the RH cylinder bank | Power and Grounding Component Views in Wiring Systems | -- |
P100 | Main wiring pass-through on the bulkhead | Harness Routing Views in Wiring Systems | -- |
S101 | In the engine harness, 20 cm (8 in) from the generator breakout toward the fuel injector breakout | Harness Routing Views in Wiring Systems | -- |
S102 | In the engine harness, 27 cm (11 in) from the fuel injector breakout toward the generator breakout | Harness Routing Views in Wiring Systems | -- |
S105 | In the engine harness, 13 cm (5 in) from the generator breakout toward the fuel injector breakout | Harness Routing Views in Wiring Systems | -- |
S110 | In the breakout for the PCM connectors, approximately 10 cm (4 in) from the main engine harness | Harness Routing Views in Wiring Systems | -- |
S116 | In the main engine harness, 13 cm (5 in) from the breakout for the ABS system toward the engine wiring harness junction block (underhood fuse relay center) | Harness Routing Views in Wiring Systems | -- |
S121 | In the branch to the engine wiring harness junction block (underhood fuse relay center) 40 cm (16 in) from the main engine harness | Harness Routing Views in Wiring Systems | -- |
S123 | In the engine harness, 56 cm (22 in) from connector C100 | Harness Routing Views in Wiring Systems | -- |
S202 | In the IP harness, approximately 16 cm (6 in) toward the IP wiring harness junction block from the breakout for the transmission range control | Harness Routing Views in Wiring Systems | -- |
S221 | In the IP harness, approximately 9 cm (3 in) toward the speedometer adapter module from the transmission controller breakout | Harness Routing Views in Wiring Systems | -- |
S232 | In the IP harness breakout for the fuse block, approximately 60 cm (24 in) from the breakout for C202 and C203 | Harness Routing Views in Wiring Systems | -- |
S234 | In the IP extension harness, 19 cm (7 in) from the instrument cluster connector | -- | -- |
S235 | In the IP extension harness, 12 cm (5 in) from the instrument cluster connector | -- | -- |
