GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Chevy P12 Chassis 🢒 Engine 🢒 Engine Exhaust 🢒 Exhaust Seal Replacement

Removal Procedure

    Object Number: 223736 Size: SH
  1. Remove the following parts from the exhaust manifold:
    2. • Exercise caution handling pipes that contain an oxygen sensor. Do not cut the wire. For removal disconnect the connector.
    • Remove the retaining nuts.
    • Remove the springs.
    • Remove the washers.
    • Remove the seals.
  2. Inspect all of the components for the following damage. Replace the components as necessary:
    3. • Cracks
    • Bends
    • Stripped threads
    • Corrosion damage
    • Leaks

Installation Procedure

    Object Number: 223736 Size: SH
  1. Install the seals.
  2. Install the pipe.
  3. Install the springs.
  4. Install the washers.

    5. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the nuts.

    6. Tighten
    Tighten the exhaust pipe nuts to the exhaust manifold mounting studs to 65 N·m (48 lb ft).