Removal Procedure
- Set the parking brake.
- Block the vehicle rear wheels.
- Lift the vehicle frame until the front tire is off the ground. Refer to Lifting and Jacking the Vehicle in General Information.
- Support the frame using suitable safety stands.
- Remove the bolts and the washers.
- Remove the hub cap and the gasket. DO NOT allow the gasket material to fall into the hub.
- Remove the cotter pin.
- Adjust the nut.
- Back off the nut 1/4-1/6 turn until the slot in the nut lines up with the hole in the spindle of the steering knuckle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the nut to 153 N·m (113 lb ft) while
rotating the wheel 360 degrees in both directions. This rotation will
correctly position the bearings.
Important: Always back off the nut 1/4-1/6 turn. This adjustment should result in bearing end play of 0.025-0.200 mm (0.001-0.008 in).
Installation Procedure
- Install a new cotter pin. Bend the cotter pin for proper clearance of the rotating components.
- Install a new gasket and align the gasket properly. Attach the hub cap.
- Install the hub cap bolts with new washers.
- Remove the safety stands.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the hub cap bolts evenly to 13 N·m (115 lb in).
