Brake Drum Replacement for Chevrolet Chevy P32 RV/Van Chassis 1998

1. Raise the vehicle and support the vehicle with safety stands. Refer to Lifting and Jacking the Vehicle in General Information.

Important: Ensure the park brake is released.

2. Remove the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement or Three-Piece Propeller Shaft Replacement .




Important:  Cap the end of the transmission in order to minimize fluid loss.

3. Remove the parking brake drum and yoke assembly mounting bolt and washer.



4. Remove the brake drum and yoke assembly.
5. Remove the yoke from the drum assembly.
6. Inspect the yoke ears for damage and the splines for the following damage:

•

Wear

•

Burrs

•

Twisting

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the bolts and the washer holding the drum assembly to the yoke.

Tighten
Tighten the bolts and the washer to 58 N·m (43 lb ft).

2. Install the parking brake drum and yoke assembly.

Tighten
Tighten the bolt to 110 N·m (81 lb ft).




3. Install the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement or Three-Piece Propeller Shaft Replacement .
4. Adjust the parking brake. Refer to Park Brake Cable Service/Adjustment .
5. Lower the vehicle.