Mode Valve Actuator Replacement W/O D07

Notice: In order to avoid actuator damage, DO NOT apply power to the actuator when it is not installed in the HVAC module.

1. Remove the floor air outlet duct extension (1) from the floor duct (2).



2. Disconnect the electrical connection at the mode actuator (1).
3. With a small flat blade tool, release the locking tab and remove mode valve lever gear (2).



4. Remove the mode actuator mounting screws from the HVAC module.
5. Remove the mode actuator as an assembly with the actuator cam.

1. Install the mode actuator as an assembly with the actuator cam.

•	Line up the heater/defroster valve lever with the mode actuator cam slot.

•	Line up the A/C valve lever with the mode actuator cam.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the mode actuator mounting screw to the HVAC module.

Tighten
Tighten the screw to 1.6 N·m (14 lb in).




3. Install the mode valve lever gear (2).
4. Connect the electrical connection at the mode actuator (1).



5. Install the floor air outlet duct extension (1) to the floor air duct (2).