For 1990-2009 cars only
Removal Procedure
- Remove the battery and battery tray from the vehicle. Refer to Battery Tray Replacement in Engine Electrical.
- Remove the inner wheel housing from the vehicle. Refer to Front Fender Replacement in Body Front End.
- Disconnect the electrical connector from the washer pump.
- Disconnect the electrical connector from the washer solvent level sensor.
- Disconnect the washer hose from the washer pump.
- Remove the upper bolt from the washer solvent container.
- Remove the lower bolts from the washer solvent container.
- Remove the washer solvent container from the vehicle.
Installation Procedure
- Install the washer solvent container into the vehicle.
- Install the lower bolts.
- Install the upper bolt.
- Connect the electrical connector to the washer pump.
- Connect the electrical connector to the washer solvent level sensor.
- Connect the washer hose to the washer pump.
- Install the inner wheel housing. Refer to Front Fender Replacement in Body Front End.
- Install the battery and battery tray. Refer to Battery Tray Replacement in Engine Electrical.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 9 N·m (80 lb in).
Tighten
Tighten the bolt to 9 N·m (80 lb in).
