GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Chevy Suburban - 2WD 🢒 Body and Accessories 🢒 Wipers/Washer Systems 🢒 Windshield Wiper Transmission Replacement

Removal Procedure

Tools Required

J 39232 Wiper Transmission Separator


    Object Number: 348540 Size: SH
  1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
  2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  3. Remove the four bolts and the reinforcement panel.

    4. Object Number: 348725 Size: SH
  4. Disconnect the electrical connector from the wiper motor.

    5. Object Number: 348543 Size: SH
  5. Remove the two bolts from the wiper transmission assembly.
  6. Remove the wiper transmission assembly from the vehicle

    7. Object Number: 306506 Size: SH
  7. Remove the drive link from the wiper motor crank arm with the J 39232 .

    8. Object Number: 513716 Size: SH
  8. Remove the two bolts retaining the wiper motor.
  9. Remove the wiper motor from the wiper transmission assembly.

Installation Procedure

Tools Required

J 39529 Wiper Transmission Installer

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 513716 Size: SH
  1. Install the wiper motor onto the wiper transmission assembly with the two bolts.

    2. Tighten
    Tighten the two bolts to 8 N·m (71 lb in).


    Object Number: 306515 Size: SH
  2. Install the drive link onto the wiper motor crank arm with the J 39529 .

    3. Object Number: 348543 Size: SH
  3. Install the wiper transmission assembly on the vehicle with the two bolts.

    4. Tighten
    Tighten the two bolts to 9 N·m (80 lb in).


    Object Number: 348725 Size: SH
  4. Connect the electrical connector to the wiper motor .

    5. Object Number: 348540 Size: SH
  5. Install the reinforcement panel with the four bolts.

    6. Tighten
    Tighten the four bolts to 9 N·m (80 lb in).

  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  7. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .
  8. Operate the wipers and check for proper operation.