GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Chevy Suburban - 2WD 🢒 Brakes 🢒 Disc Brakes 🢒 Front Brake Caliper Bracket Replacement

Removal Procedure

    Notice: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

  1. Remove the caliper from the mounting bracket and support the caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake flexible hose from the caliper. Refer to Front Brake Caliper Replacement .

    2. Object Number: 369668 Size: SH
  2. Remove the brake pads.
  3. Remove the anti-rattle clips from the brake caliper bracket.

    4. Object Number: 177036 Size: SH
  4. Remove the brake caliper bracket mounting bolts (2).
  5. Remove the brake caliper bracket (1).
  6. Remove any contaminants or foreign material from the inside ends of the brake caliper bracket.
  7. Clean the mounting surface and threads of the brake caliper bracket.

Installation Procedure

    Object Number: 177036 Size: SH
  1. Install the brake caliper bracket (1).
  2. Perform the following procedure before installing the brake caliper bracket mounting bolts.
    3. • Remove all traces of the original adhesive patch.
    • Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    • Apply Threadlocker GM P/N 12345493 or RED LOCTITE™ #272 to the threads of the bolt.

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the caliper bracket mounting bolts (2).

    4. Tighten

        • Tighten the brake caliper bracket mounting bolts to 175 N·m (121 lb ft) (15 Series).
        • Tighten the brake caliper bracket mounting bolts to 300 N·m (221 lb ft) (25 and 35 Series).

    Object Number: 369668 Size: SH
  4. Install the anti-rattle clips to the brake caliper bracket.
  5. Install the brake pads to the brake caliper bracket.
    6. • Install the inner pad (1 wear indicator).
    • Install the inner pad (2 wear indicators).
  6. Slide the brake pads in until they contact the rotor.
  7. Install the brake caliper. Refer to Front Brake Caliper Replacement .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  9. Lower the vehicle.
  10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
  11. Slowly release the brake pedal.
  12. Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.