For 1990-2009 cars only
Removal Procedure
- Open the lift gate.
- Support the lift gate.
- Remove the roof rear header garnish molding. Refer to Rear Upper Garnish Molding Replacement in Interior Trim.
- Disconnect the electrical connectors, as needed.
- Disconnect the lift gate window washer fluid hose.
- Remove the lift gate struts. Refer to Liftgate Strut Replacement .
- Remove the bolts retaining the lift gate hinge to the body mounted hinge locator.
- With an assistant, remove the lift gate.
Installation Procedure
- With an assistant, install the lift gate to the vehicle.
- Install the bolts that retain the lift gate to the body.
- Install the lift gate struts. Refer to Liftgate Strut Replacement .
- Connect the washer fluid hose.
- Connect the electrical connectors, as needed.
- Install the roof rear header garnish molding. Refer to Rear Upper Garnish Molding Replacement in Interior Trim.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 25 N·m (18 lb ft).
