Circuit Description
This DTC identifies a malfunction within the electronic brake control module (EBCM).
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The EBCM detects an internal malfunction.
Action Taken When the DTC Sets
If equipped, the following actions may occur:
| • | The EBCM disables the ABS/TCS/VSES and DRP. |
| • | The ABS indicator turns ON. |
| • | The traction off indicator turns ON. |
| • | The red brake warning indicator turns ON. |
| • | The message center displays the SERVICE STABILITY SYSTEM message. |
Conditions for Clearing the DTC
The conditions for setting the DTC are no longer present and you use the scan tool Clear DTCs function.
Diagnostic Aids
Replace the EBCM if DTC C0273 or DTC C0284 continues to set intermittently.
Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the ABS Diagnostic System Check? | Go to Step 2 | |
2 | Is DTC C0271 or DTC C0272 set in the EBCM memory? | Go to Step 4 | Go to Step 3 |
3 |
Does the DTC set? | Go to Step 4 | Go to Diagnostic Aids |
4 |
Important: Following EBCM replacement, use the scan tool to perform the Tire Size Calibration procedure and the Trim Level Calibration procedure, if applicable. Replace the EBCM. Refer to Electronic Brake Control Module Replacement . Did you complete the replacement? | Go to Step 5 | -- |
5 | Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Does the DTC reset? | Go to Step 2 | System OK |
