For 1990-2009 cars only
Removal Procedure
- Remove the steering wheel. Refer to Steering Wheel Replacement .
- Remove the horn switch from the steering wheel.
- Remove the steering wheel shroud retaining screws from the back of the steering wheel.
- Remove the steering wheel shroud from the steering wheel.
- Remove the steering wheel control switch mounting screws.
- Disconnect the steering wheel control switch (2) electrical connector (1).
- Remove the steering wheel control switch from the steering wheel.
Installation Procedure
- Install the steering wheel control switch to the steering wheel.
- Install the steering wheel control switch mounting screws.
- Connect the electrical connector (1) to the steering wheel control switch.
- Install the horn switch to the steering wheel.
- Install the steering wheel. Refer to Steering Wheel Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the mounting screws to 2 N·m (20 lb in).
Tighten
Tighten the steering wheel horn switch to 5.5 N·m (50 lb in).
