Removal Procedure
- Remove the oil pan. Refer to Oil Pan Replacement .
- Remove the oil pump bolt from the crankshaft main bearing cap.
- Remove the oil pump.
- Inspect the oil pump pickup tube and the screen for damage or looseness.
- If the oil pump tube is damaged or loose, replace the oil pump.
The pickup tube and the screen are not serviced separately.
Installation Procedure
- Install the oil pump to the engine.
- Install the oil pump to the crankshaft main bearing cap bolt.
- Install the oil pan. Refer to Oil Pan Replacement .
| 1.1. | Align the slot in the oil pump shaft with the tang on the distributor shaft. |
| 1.2. | The oil pump should slide easily into place. |
| 1.3. | Do not use a gasket. |
Tighten
Tighten the crankshaft main bearing cap bolt to 90 N·m
(65 lb ft).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
