GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Chevy Suburban - 4WD 🢒 Steering 🢒 Steering Wheel and Column - Standard 🢒 Electronic Column Lock Module - Assemble - Off Vehicle

Electronic Column Lock Module - Assemble - Off Vehicle Column Shift

Assembly Procedure

    Object Number: 306295 Size: SH
  1. Install the lock module assembly (2).

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the 3 pan head tapping screws (1) into the lock module assembly.

    3. Tightens
    Tighten the screws to 1.4 N·m (12 lb in).

  3. Install the ignition and key alarm switch assembly. Refer to Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle Turn Signal and Multifcn Sw Assembly - Assemble (Column Shift).

Electronic Column Lock Module - Assemble - Off Vehicle Floor Shift

Assembly Procedure

    Object Number: 306295 Size: SH
  1. Install the lock module assembly (2).

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the 3 pan head tapping screws (1) into the lock module assembly.

    3. Tightens
    Tighten the screws to 1.4 N·m (12 lb in).

  3. Install the ignition and key alarm switch assembly. Refer to Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle Turn Signal and Multifcn Sw Assembly - Assemble (Floor Shift).