Tools Required

Was the Audible Warnings Diagnostic System Check performed?

--

Go to Step 2

Go to Diagnostic System Check - Audible Warnings

1. Turn the ignition switch to the RUN position.
2. Remove the audio alarm module.
3. Connect a test lamp from cavity K4 of the convenience center to ground.

Did the test lamp light?

--

Go to Step 3

Go to Step 4

1. Unfasten the left front seat belt.
2. Connect a test lamp from cavity K1 of the convenience center to B+.

Did the test lamp light?

--

Go to Step 5

Go to Step 6

Locate and repair the open in CKT 39 (PNK) between the convenience center and the IP fuse block. Refer to Wiring Repairs in wiring.

Is the repair complete?

--

Go to Diagnostic System Check - Audible Warnings

--

Replace the audio alarm module.

Is the repair complete?

--

Go to Diagnostic System Check - Audible Warnings

--

1. Disconnect connector C211 of the seat belt switch.
2. Connect a test lamp between cavity A of the seat belt switch connector C211 and B+.

Did the test lamp light?

--

Go to Step 7

Go to Step 8

1. Connect a jumper wire between cavity A and cavity B of seat belt switch connector C211, harness side.
2. Connect a test lamp between cavity K1 of the audio alarm module cavity to B+.

Did the test lamp light?

--

Go to Step 9

Go to Step 10

Locate and repair the open in CKT 150 (BLK) between the seat belt switch connector and ground. Refer to Wiring Repairs in wiring.

Is the repair complete?

--

Go to Diagnostic System Check - Audible Warnings

--

Replace the left front seat belt switch. Refer to

Is the repair complete?

--

Go to Diagnostic System Check - Audible Warnings

--

Locate and repair the open in CKT 238 (BLK/WHT) between the seat belt switch and the audio alarm module. Refer to Wiring Repairs in wiring.

Is the repair complete?

--

Go to Diagnostic System Check - Audible Warnings

--