GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Chevy Suburban - 4WD 🢒 Brakes 🢒 Hydraulic Brakes 🢒 Brake Pedal Replacement

Removal Procedure

    Object Number: 344194 Size: SH
  1. Remove the pushrod retaining clip (4).
  2. Remove the stoplamp switch (2) and the pushrod (3) from the brake pedal stud (1).

    3. Object Number: 375693 Size: SH
  3. Remove the nut from the brake pedal bolt.
  4. Remove the brake pedal bolt.
  5. Remove the brake pedal.

Installation Procedure

    Object Number: 375693 Size: SH
  1. Install the brake pedal.
  2. Install the brake pedal bolt.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the nut to the brake pedal bolt.

    4. Tighten
    Hold the nut with a wrench and tighten the brake pedal bolt to 47 N·m (35 lb ft).


    Object Number: 344194 Size: SH
  4. Install the pushrod (3) and the stoplamp switch (2) to the brake pedal pin (1).
  5. Install the pushrod retaining clip (4).