For 1990-2009 cars only
Removal Procedure
- Remove the ashtray from the instrument panel (IP) by depressing the tab and sliding the ashtray rearward.
- Remove the lower IP trim panel. Refer to Instrument Panel Lower Trim Panel Replacement .
- Remove the ashtray lamp wiring harness from the ashtray housing.
- Remove the screws holding the ashtray housing to the rear of the IP lower trim panel.
- Remove the ashtray housing from the lower trim housing.
Installation Procedure
- Install the ashtray housing to the lower IP trim panel.
- Install the screws holding the ashtray housing to the rear of the IP lower trim panel.
- Connect the ashtray lamp wiring harness to the ashtray housing.
- Install the lower IP trim panel. Refer to Instrument Panel Lower Trim Panel Replacement .
- Insert the ashtray to the IP by depressing the tab and sliding the ashtray forward.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the ashtray housing screws to 2 N·m (18 lb in).
