Removal Procedure
Important: Do not grab or pull on the CD storage door when removing the trim bezel.
- Remove the screws securing
the trim bezel to the console extension.
- Protect the console extension from damage then carefully use a
small prying device to push in the tabs underneath the trim bezel securing
the top of the trim bezel.
- Remove the trim bezel.
- To remove the bezel on the luxury console, refer to
Floor Console Bezel Replacement
.
- Use a small screwdriver
in order to release the CD player retainers.
- Slide the CD player out .
- Disconnect the electrical connector.
Installation Procedure
- Connect the electrical
connector.
- Install the CD player.
- When the CD player is fully seated, snap the unit into the retainers.
- To install the bezel on the luxury console, refer to
Floor Console Bezel Replacement
.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the trim bezel and the screws.
Tighten
Tighten the screws to 2 N·m (18 lb in).
- Verify the component operation.