Schematic Reference: Wiper/Washer Schematics

Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Wiper/Washer Systems

Turn the ignition ON.

Are the windshield washers always on?

Go to Step 3

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

1. Turn the ignition OFF.
2. Disconnect the inline harness connector C201.
3. Remove the connector terminal row E from steering column harness connector half.
4. Connect the inline harness connector C201.
5. Turn the ignition ON.

Are the windshield washers always on?

Go to Step 4

Go to Step 5

Repair the windshield washer pump control circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Is the repair complete?

Go to Step 6

--

Replace the windshield wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column.

Is the repair complete?

Go to Step 6

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3