Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Fog Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Body Control System Connector End Views in Body Control System. | |||
1 | Did you perform the Lighting Systems Diagnostic System Check? | Go to Step 2 | |
2 | Verify that the rear fog lamps are always on. Do the rear fog lamps operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | Use the scan tool to monitor the rear fog lamp switch input while depressing the switch several times. Does the scan tool indicate that the switch is ACTIVE at all times? | Go to Step 4 | Go to Step 5 |
4 | Test for a short to ground in the rear fog lamp switch signal circuit. Did you find and correct the condition? | Go to Step 13 | Go to Step 11 |
5 | Test the rear fog lamp relay control circuit for a short to ground. Did you find and correct the condition? | Go to Step 13 | Go to Step 6 |
6 | Remove the rear fog lamp relay. Do the rear fog lamps turn OFF? | Go to Step 7 | Go to Step 9 |
7 |
Was a ground signal found? | Go to Step 8 | Go to Step 12 |
8 | Inspect for poor connections at the harness connector of the Body Control Module (BCM). Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 13 | Go to Step 10 |
9 | Repair the short to voltage in the rear fog lamp supply voltage circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 13 | -- |
10 |
Important: Perform the setup procedure for the BCM. Replace the body control module (BCM). Refer to Body Control Module Replacement in Body Control System. Did you complete the replacement? | Go to Step 13 | -- |
11 | Replace the rear fog lamp switch. Refer to Rear Fog Lamp Switch Replacement . Did you complete the repair? | Go to Step 13 | -- |
12 | Replace the rear fog lamp relay. Refer to Relay Replacement in Wiring Systems. Did you complete the repair? | Go to Step 13 | -- |
13 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |