Fuel Level Sensor Replacement 2500 Series - Rear Tank

1. Remove the sending unit. Refer to Fuel Sender Assembly Replacement .
2. Disconnect the fuel level sensor electrical connector.
3. Remove the fuel level sensor retaining clip.
4. Squeeze the locking tangs and remove the fuel level sensor (4).

1. Install the fuel level sensor (4).
2. Connect the fuel level sensor electrical connector.
3. Install the fuel level sensor retaining clip.
4. Install the sending unit. Refer to Fuel Sender Assembly Replacement .

Fuel Level Sensor Replacement Suburban/Yukon XLT

1. Remove the sending unit. Refer to Fuel Sender Assembly Replacement .
2. Disconnect the fuel pump electrical connector.



3. Remove the fuel level sensor electrical connector retaining clip.



4. Disconnect the sending unit electrical connector.



5. Remove the fuel level sensor retaining clip.



6. Squeeze the locking tangs together, and remove the fuel level sensor.

1. Install the fuel level sensor.



2. Install the fuel level sensor retaining clip.



3. Connect the sending unit electrical connector.



4. Install the fuel level sensor electrical connector retaining clip.



5. Connect the fuel pump electrical connector.
6. Install the sending unit. Refer to Fuel Sender Assembly Replacement .

Fuel Level Sensor Replacement Avalanche/Escalade EXT

1. Remove the sending unit. Refer to Fuel Sender Assembly Replacement .
2. Place the sending unit on a clean work surface.
3. Disconnect the fuel level sensor electrical connector (1) from the module connector.



4. Remove the fuel level sensor retaining clip.




Important: Extreme care must be used when disengaging the locking tabs on the reservoir, failure to do so may result in the sender being unusable.

5. Release the fuel sender reservoir retaining tabs on both sides of the reservoir (1).



6. Remove the fuel level sensor wires from around the reservoir retaining tabs.
7. Separate the module from the reservoir.



8. Squeeze the retaining tabs together in order to slide the fuel lever sensor off of the reservoir.

1. Slide the fuel lever sensor onto the reservoir until the retaining tabs snap into place.



2. Slide the module into the reservoir.
3. Route the fuel level sensor wires around the reservoir retaining tabs.



4. Snap the sending unit reservoir retaining tabs (1) into both sides of the reservoir.



5. Install the fuel level sensor retaining clip.



6. Connect the fuel level sensor electrical connector (1) to the module connector.
7. Install the sending unit. Refer to Fuel Sender Assembly Replacement .