For 1990-2009 cars only
Removal Procedure
- Remove the rear door outer belt sealing strip screw (1) from the rear door outer belt sealing strip (2).
- Pull up on the door outer belt sealing strip (2) in order to release the strip from the retaining clips.
- Remove the rear door outer belt sealing strip (2) from the door.
Installation Procedure
- Align the rear door outer belt sealing strip clips to the slots in the rear door. Push down until an audible snap is heard at each retaining clip in order to engage the door outer sealing strip (2) to the rear door.
- Install the rear door outer belt sealing strip screw (1) to the rear door outer belt sealing strip (2).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the rear door outer belt sealing strip screw to 1 N·m
(9 lb in).
