Removal Procedure
- Remove the washer solvent from the washer solvent container.
- Disconnect the washer pump electrical connector.
- Disconnect the washer hose from the washer pump.
- Disconnect the washer solvent level sensor electrical connector.
- Remove the washer solvent container screws.
- Remove the washer solvent container from the frame rail.
Installation Procedure
- Position the washer solvent container to the
frame rail.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the washer solvent container screws.
Tighten
Tighten the screws to 6 N·m (53 lb in).
- Connect the washer solvent level sensor electrical connector.
- Connect the washer hose to the washer pump.
- Connect the washer pump electrical connector.
- Fill the washer solvent container with washer solvent.