GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Classic 🢒 Engine 🢒 Engine Mechanical - 2.2L (L61) 🢒 Camshaft Cover Replacement

Removal Procedure
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  2. Remove the air outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement in Engine Controls-2.2L (L61).
  3. Remove the accelerator and cruise control cables bracket.
  4. Remove the PCV hose.
  5. Remove the fuel line brackets.
  6. Remove the brake booster hose/pipe from it's bracket.

    7. Object Number: 412144 Size: SH
  7. Remove the ignition coil and module assembly.

    8. Object Number: 412139 Size: SH
  8. Remove the ground strap.

    9. Object Number: 412147 Size: SH
  9. Remove the camshaft cover bolts.
  10. Remove the camshaft cover.

Installation Procedure

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 412147 Size: SH
  1. Install the camshaft cover and bolts.

    2. Tighten
    Tighten the camshaft cover bolts to 10 N·m (89 lb in).


    Object Number: 412139 Size: SH
  2. Install the ground strap.

    3. Tighten
    Tighten the ground strap bolt to 10 N·m (89 lb in).


    Object Number: 412144 Size: SH
  3. Install the ignition coil and module assembly.

    4. Tighten
    Tighten the ignition coil and module assembly bolt to 10 N·m (89 lb in).

  4. Install the brake booster hose/pipe to it's bracket.
  5. Install the fuel line bracket.

    6. Tighten
    Tighten the fuel line bracket bolt to 10 N·m (89 lb in).

  6. Install the accelerator and cruise control cables bracket.

    7. Tighten
    Tighten the accelerator and cruise control cables bracket bolt to 10 N·m (89 lb in).

  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.