GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Classic 🢒 Engine 🢒 Engine Controls - 2.2L (L61) 🢒 Ignition Control Module Replacement

Removal Procedure
  1. Turn OFF the ignition.
  2. Remove the accelerator cable from the bracket.
  3. Remove the accelerator cable bracket bolt.
  4. Remove the accelerator cable bracket.

    5. Object Number: 783965 Size: SH
  5. Disconnect the ignition control module (ICM) harness connector.
  6. Remove the ICM retaining screws.
  7. Remove the ICM from the ignition coil housing.

Installation Procedure

    Object Number: 783965 Size: SH

    Important: Make sure the interconnect and seal are lined up before module installation.

  1. Install the ignition control module in the ignition coil housing.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the ICM retaining screws.

    3. Tighten
    Tighten the retaining screws to 1.5 N·m (13 lb in).

  3. Connect the ICM harness connector.
  4. Install the accelerator cable bracket.

    5. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the accelerator cable bracket bolt.

    6. Tighten
    Tighten the retaining screws to 10 N·m (18 lb in).

  6. Install the accelerator cable to the bracket.
  7. Refer to Control Module References for programming and setup information.