Caution: If a window is cracked but still intact, crisscross the window with
masking tape in order to reduce the risk of damage or personal injury.
Important: Before cutting out a stationary window, apply a double layer of masking
tape around the perimeter of the painted surfaces and inner trim.
- Open the rear compartment lid in order to access the reveal molding (1).
- Remove the rear window
reveal molding (1). Refer to
Rear Window Reveal Molding Replacement
.
- Remove the rear seat cushion. Refer to
Rear Seat Cushion Replacement
in Seats.
- Remove the rear seat back. Refer to
Rear Seat Back Replacement
in Seats.
- Remove the rear quarter trim panels. Refer to
Rear Quarter Upper Trim Panel Replacement
in Interior Trim.
- Disconnect the rear window electrical connectors.
Caution: If broken glass falls into the defroster outlets, it can be blown into
the passenger compartment and cause personal injury.
- Cover to protect the following parts from broken glass:
| • | Defroster outlets and A/C outlets |
Caution: When working with any type of glass or sheet metal with exposed or rough
edges, wear approved safety glasses and gloves in order to reduce
the chance of personal injury.
Important: The rear window reveal molding fills the cavities between the body and
rear window and cannot be reused if stretched or damaged.
- Remove the rear window reveal molding (1).
- If the window reveal
molding (1) will not release, use a utility knife in order to cut around
the window in order to remove the window reveal molding (1).
Important: Keep the cutting edge of the tool against the window.
- This will allow the urethane adhesive to be separated from the window.
| • | Leave a base of urethane on the pinchweld flange. |
| • | The only suitable lubrication is clear water. |
- With the aid of an assistant,
use the suction cups in order to lift the rear window from the opening.
