Removal Procedure
- Remove the drive belt. Refer to
Drive Belt Replacement
.
- Remove the evaporative emission (EVAP) tube and EVAP valve.
- Remove the throttle body and gasket. Refer to
Throttle Body Assembly Replacement
.
- Remove the supercharger inlet pressure (SCIP) sensor .
- Disconnect the vacuum brake booster hose.
- Remove the intercooler fill neck bracket bolts.
- Remove the vacuum line from the supercharger.
- Remove the supercharger . Remove the gasket if damaged.
Installation Procedure
- Install the supercharger gasket.
Notice: Refer to Fastener Notice in the Preface section.
- Install the supercharger and bolts.
Tighten
Tighten the bolts to 25 N·m (18 lb ft).
- Install the intercooler fill neck bracket bolts.
Tighten
Tighten the bolts to 10 N·m (89 lb in).
- Connect the vacuum brake booster hose.
- Install the SCIP sensor and bolt.
Tighten
Tighten the bolts to 10 N·m (89 lb in).
- Install the throttle body. Refer to
Throttle Body Assembly Replacement
.