- Assemble the camshaft cover and gasket. Ensure that the gasket is located in the retaining groove in the camshaft cover.
- Install the cover on the cylinder head and hand start the bolts.
- Install the spark plugs.
- Install the ignition coil and module assembly bolts to the cam cover.
- Install the ignition coil and module assembly bolts.
- Install the ignition coil cover.
- Install the ignition coil cover bolts.
- Install the lift hook.
- Install the lift hook bolts.
- Install the camshaft position sensor.
- Install the camshaft position sensor bolt.
- Install the power steering blockout plate.
- Install the power steering blockout plate studs.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the camshaft cover bolts to 8 N·m (71 lb in).
Tighten
Tighten the spark plugs to 20 N·m (15 lb ft).
Tighten
Tighten the ignition coil and module assembly bolts to 8 N·m (71 lb in).
Tighten
Tighten the bolts to 8 N·m (71 lb in).
Tighten
Tighten the bolts to 22 N·m (16 lb ft).
Tighten
Tighten the bolt to 8 N·m (71 lb in).
Tighten
Tighten the power steering blockout plate bolts to 25 N·m (18 lb ft).
