Circuit Description
The body control module (BCM) supplies battery positive voltage to the courtesy lamps, underhood lamp, instrument panel (I/P) compartment lamp, console lamp, and both visor vanity mirror lamps. In the event that any of these lamps were to remain illuminated for more than 20 minutes with the ignition switch in the OFF position, the BCM will deactivate the inadvertent power courtesy lamps supply voltage circuit to prevent a total battery discharge condition.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B1480 Battery Rundown Protection Circuit
Conditions for Running the DTC
The battery voltage must be between 9-16 volts.
Conditions for Setting the DTC
B1480 00
The inadvertent power courtesy lamps supply voltage circuit to the courtesy lamps, underhood lamp, I/P compartment lamp, console lamp, and both visor vanity mirror lamps are shorted to ground for longer than 1 second.
Action Taken When the DTC Sets
The courtesy lamps, underhood lamp, I/P compartment lamp, console lamp, and both visor vanity mirror lamps will not operate.
Conditions for Clearing the DTC
| • | This DTC will clear on current status after the condition for setting the fault is corrected. |
| • | A history DTC will clear after 100 consecutive ignition cycles without a fault present. |
| • | History and current DTCs can be cleared using a scan tool. |
Diagnostic Aids
Perform a visual inspection for loose or poor connections at all related components. Refer to Testing for Intermittent Conditions and Poor Connections .
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Interior Lights Schematics Connector End View Reference: Master Electrical Component List | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 |
Is DTC B1480 present? | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections |
3 | Test the inadvertent power courtesy lamps supply voltage circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 5 | Go to Step 4 |
4 | Replace the body control module (BCM). Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 5 | -- |
5 |
Does the DTC reset? | Go to Step 2 | System OK |
